Setup Instruction
Last updated
Last updated
Do not upgrade your firmware if your box was not activated before 2024.8.31;
Normal upgrading is supported if your box was activated before 2024.8.31.
Setup your Kmbox B+ as image below:
Note: if you are gaming on a single PC, cables plugged to "port serial" and "controlled PC" should both be connected to the gaming PC.
After plugging the cable to the Net port, a disk will appear as shown in the picture below.
Double-click the disk and run the exe file inside.
If no disk to be found, download the driver mannually.
Open Control Panel -> Network and Sharing Center
Change IP Address
Run cmd.exe
Check if the IP on the kmbox could be successfully pigged
If the above is shown, the box is ready. Now you can refer to your dma software for further instructions.